The program guide seems corrupt, how can I force my H3 to download it now? I have done a hard reset, check switch and putting it in standby for a while but no go and although there is a good bit of the guide that is correct also 36 hours says "no information available"
Make sure nothing is recording for the next half hour and then place all of your receivers in stand by. Wait the full half hour before using your receivers again. If the issue persists, we may need to replace the receiver. Shoot me a PM if this is the case.
I had tried that and nothing happened, the not so smart offshore CSR told me to disconnect the antenna and run check switch. That is what I had to do to get my 922 to force an EPG download. Well I tried it but nothing happened, so I stopped it. I rebooted without the antenna and then connected the antenna, it took longer than normal to run check switch. Then I put it in standby and it immediately downloaded the EPG. Timers still did not work but did after another reboot. Now all is well.